Page 1 of 1

Support generation issue - Ragged lines

Posted: Tue Apr 06, 2021 2:15 pm
by Help3D
Why this big difference between S3D and IDM in support generation ?

Here the Gcode: https://we.tl/t-pvY2Q1JWuE

Re: Support generation issue - Ragged lines

Posted: Wed Apr 07, 2021 4:23 am
by Vicky@Raise3D
You can try support with larger pillar size.

Re: Support generation issue - Ragged lines

Posted: Wed Apr 07, 2021 8:24 am
by Help3D
it is working only if selecting "pillar mode" and not "normal", why ?

Re: Support generation issue - Ragged lines

Posted: Thu Apr 08, 2021 2:40 am
by Vicky@Raise3D
With normal type support, ideaMaker will use smaller sampling size to take sample to generate support.
There will be no defined sampling size to generate pillar type support. The size of each pillar is the size of sampling.