Heat up in advance not working 4.1.0.4990

[Help3D]

Hi

In this version heating up in advance is not working, i can spot the M109 only when is changing the extruder and not X seconds before as usual. Is this a bug ? I tried with all of my profiles and is not working.

Feature: is possible to change the extruder over the wipe tower instead on the piece that is printing ?

[Vicky@Raise3D]

Would you like to share the .gcode, .data and .idea files having issues with us?
You can enable Move to park position to avoid nozzle switching above the model.

[Help3D]

Hi !

Just try with a simple cube 40X40 mm with 20% infill !

[Vicky@Raise3D]

M109 is a heat waiting code. It needs somewhere to wait the nozzle to heatup. So Move to park positione needs to be enabled.
Preheat code is M104. This one doesn't need to wait.

[Help3D]

ok... but heating in ADVANCE is using M109 not M104. Otherwise will be useless ...

Try to enable the Heating in Advance of 60 seconds

[Vicky@Raise3D]

If using M109 for heating in advance, then the print will pause and waiti for heatup in mid of a print. Heating in advance for inactive extruder should be M104.

[Help3D]

If using M109 for heating in advance, then the print will pause and waiti for heatup in mid of a print. Heating in advance for inactive extruder should be M104.

Still no success... can you try with 4.1 ? Heating in advance is not working !

[Vicky@Raise3D]

We have tried slicing with similar settings as your with the models under Sampler. The heating in advance works on our end.
T0 heat in advance then T1 continues the print and switch extruder goes back to T0.