Setup Question

Discussions about ideaMaker and other printing software.
Cas
Posts: 1
Joined: Mon Feb 15, 2021 9:39 am

Setup Question

Postby Cas » Mon Feb 15, 2021 9:44 am

HI, first time here, just got into print before Christmas and after getting used to printing quite a few items I would like
to move over from Cura to IdeaMaker but I need some assistance/guidance in setting up IdeaMaker to slice models for
the Ender 3 V2 machine, is that OK to discuss here ?

Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests