Font is too large, descriptions cut off

Discussions about ideaMaker and other printing software.
Meetloaf13
Posts: 2
Joined: Wed Jan 13, 2021 2:46 pm

Font is too large, descriptions cut off

Postby Meetloaf13 » Wed Jan 13, 2021 2:52 pm

I am having an issue. I have anew laptop, that is natively 4K, but I run 3 monitors at 1080p.

When I launch ideaMaker 4.0.1, the scaling is off and many of the descriptions are cut off, making it difficult to view and alter settings:
Screenshot 2021-01-13 075010.png


I have tried to alter the font family/size, but when I change these settings and hit OK, the changes do not take effect and revert back to the default settings.

None of my other softwares are suffering from this.

Any help would be much appreciated. I've found that IdeaMaker is giving me better quality prints than Cura, and I'd like to continue using it.

Thank you

User avatar
Vicky@Raise3D
Posts: 7563
Joined: Fri Mar 25, 2016 3:54 am

Re: Font is too large, descriptions cut off

Postby Vicky@Raise3D » Thu Jan 14, 2021 12:25 am

If you are running ideaMaker with Windows 10, please adjust DPI settings according the screeshot below and restart ideaMaker.
Image_20210113162231.png

Meetloaf13
Posts: 2
Joined: Wed Jan 13, 2021 2:46 pm

Re: Font is too large, descriptions cut off

Postby Meetloaf13 » Thu Jan 14, 2021 7:20 pm

Bummer, no dice there.

I wonder if it needs a system restart.

User avatar
Vicky@Raise3D
Posts: 7563
Joined: Fri Mar 25, 2016 3:54 am

Re: Font is too large, descriptions cut off

Postby Vicky@Raise3D » Fri Jan 15, 2021 1:46 am

Make sure the customize font settings in ideaMaker has been disabled and close ideaMaker then reboot the computer.
https://support.raise3d.com/ideaMaker/4 ... 5-814.html


Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests