Vase mode start at height??

Discussions about ideaMaker and other printing software.
Adam_of_3den
Posts: 2
Joined: Thu Nov 19, 2020 1:24 pm

Vase mode start at height??

Postby Adam_of_3den » Thu Nov 19, 2020 1:34 pm

Hi all!
I’m looking for some help..
I’m trying to print a screw top Christmas bauble. Screw top on build plate orientation.
I’d like to print the first 25mm (the thread section of the model) as normal - shells/infill etc... At 25mm z-height onwards (the bauble part of the model) to print in spiral vase mode..

Is this possible? Can anyone help me please.....

Ps.
I’ve tried modifiers, I’ve tried group/layer settings. Slicing one model with different profiles????

Many thanks in advance
Adam

User avatar
Vicky@Raise3D
Posts: 7389
Joined: Fri Mar 25, 2016 3:54 am

Re: Vase mode start at height??

Postby Vicky@Raise3D » Thu Nov 19, 2020 11:15 pm

Thanks for your suggestions!
The request has already been added into developing list.

Labirynt
Posts: 36
Joined: Thu Jun 25, 2020 9:08 am

Re: Vase mode start at height??

Postby Labirynt » Mon Nov 23, 2020 10:48 pm

Adam_of_3den wrote:Hi all!
I’m looking for some help..
I’m trying to print a screw top Christmas bauble. Screw top on build plate orientation.
I’d like to print the first 25mm (the thread section of the model) as normal - shells/infill etc... At 25mm z-height onwards (the bauble part of the model) to print in spiral vase mode..

Is this possible? Can anyone help me please.....

Ps.
I’ve tried modifiers, I’ve tried group/layer settings. Slicing one model with different profiles????

Many thanks in advance
Adam


manual merging 2 gcodes


Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests