Pro2 RaiseTouch Settings for Acceleration and Jerk

[Markus64]

Hi Guys,
I have a few questions about the jerk and acceleration preset values which are saved directly in the printer. Are you working with the default values ​​or have you adjusted them? I find it very bad that there is no information on this in the manual.
If you have adjusted the values, I would be grateful if you post them here.

[Weisskeinen]

I modified the jerk settings on the printer to make the edges less bulky on faster print speeds. Now I'm looking for a way to include these values into the software, because the prediction of the print duration is completely wrong now. One of my last prints was predicted to last 26h, but was finished after 18h (!). My current settings for XY-Jerk is 20 and on E-Jerk is 30 on my Pro2 Plus. But I didn't print tall objects up to now. The printer runs considerably more shaky...

[Markus64]

Thanks for your feedback!
The display of the printing times only works reliably if the job is transferred via the slicer. I noticed that shortly after buying the printer. I also criticized this, but whether Raise will adapt the firmware in this view remains to be seen.
The value Max Acceleration - E is 10000 for me and I can't do anything with this value. Does this value stand for the acceleration of the extrusion or the maximum speed with which extrusion can take place? These settings are not explained in the documentation.

[Weisskeinen]

The display of the printing times only works reliably if the job is transferred via the slicer.

The jerk settings are not transferred to the slicer and the printing times currently stay as wrong as after the initial change of the settings.