Print on outer or middle of line?

Discussions about ideaMaker and other printing software.
Olly Oxenfree
Posts: 44
Joined: Sun Jun 28, 2020 12:43 pm

Print on outer or middle of line?

Postby Olly Oxenfree » Sun Oct 18, 2020 8:37 pm

Hi,
Just made a plug to go into the end of a piece of pipe. I made the diameter 0.2mm smaller so that with cooling-shrinkage should have been fine but it was too tight.

Is there a setting for the slicing to be done on the inner or center of the CAD-line?

I seem to recall that Cura had an option for "inner, center or outer" and wondering if IM has it under a different name. I have searched and not found anything to help. Or, do I just need to guess again and reduce the diameter by 0.4mm or something like that?

Thanks
Surface-Pro-2, 8-GB, 256-GB-SSD, Linux-Mint-20.0, 19.3 with Cinnamon
Retired Programmer, ASM, COBOL, Fortran, C, C++, C#, Pascal and more

Return to “Software”

Who is online

Users browsing this forum: No registered users and 1 guest