Flow Rate in duplication mode

Discussions about ideaMaker and other printing software.
ericus101
Posts: 1
Joined: Thu Oct 15, 2020 8:19 am

Flow Rate in duplication mode

Postby ericus101 » Thu Oct 15, 2020 8:32 am

I am printing with my E2 in duplication mode and I am using the same flow rate for both extruders in ideamaker. But my Printer shows different flow rates:
2020-10-15 10_23_35-Raise3D E2 - Raise3D@10.0.0.49.png
Tune display


Here my ideamaker settings:
Advanced Settings.png
settings
Advanced Settings.png (6.89 KiB) Viewed 121 times


In gcode there is one command for setting flowrate: M221 S96.00

But material usage is the same:
;Print Time: 20173
;Material#1 Used: 25953.9
;Material#2 Used: 25953.9
;Material#1 Cost: 3.55
;Material#2 Cost: 3.55

So I think my printer is showing the wrong flowrate or is he really printing with different flow rates?

s4eric
Posts: 12
Joined: Wed Jul 29, 2020 5:45 pm

Re: Flow Rate in duplication mode

Postby s4eric » Fri Oct 16, 2020 6:15 pm

Check that your Motion Controller Board has the latest firmware version.

Fixed the problem that the printing flowrate setting does not take effect on the right nozzle in Duplication Mode and Mirror Mode

https://www.raise3d.com/download/motion ... ase-notes/


Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests