Is there anyway to confirm the mesh bed leveling is working? It appears as though the offsets are not being applied, most noticeably on the first layer. The print will be squished too much on portions of the bed that are higher and not adhere as well on the lower portions. The flatness is within tolerance ~.2 and notice no difference between the simple and full bed leveling.
Auto-leveling is turned on, and I'm using the latest version of IdeaMaker. I have enabled the raft, even for small prints for the time being.
Discussions about ideaMaker and other printing software.
3 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests