Resume after stopping print

Discussions about ideaMaker and other printing software.
misslivia
Posts: 1
Joined: Fri Jan 17, 2020 8:19 pm

Resume after stopping print

Postby misslivia » Thu Jul 09, 2020 7:30 pm

Is there an option, or if not could it be built, to manually load/unload filament in the middle of a print? I've lost a few prints because of clogs that I caught early, but was unable to clear the clog without starting the print over again. Thanks!

User avatar
Vicky@Raise3D
Posts: 6939
Joined: Fri Mar 25, 2016 3:54 am

Re: Resume after stopping print

Postby Vicky@Raise3D » Thu Jul 09, 2020 11:15 pm

Does pause, then unload and load filament and resume the print after filament is ready work for you?


Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests