Discussions about ideaMaker and other printing software.
6 posts • Page 1 of 1
FOGD.NO wrote:Labirynt wrote:It should be able to place at least 6, if You move first 2 models near to left border
Then I get a message it is not able to.. And If I auto arrange them it move it like photo number 2.
60x30mm model size:
Vicky@Raise3D wrote:If you rotate the model in Z direction for 90 degrees you will have more room. E2 has more size limitations in Y direction than in X. So placing the longer side in X direction will be better.
Who is online
Users browsing this forum: No registered users and 2 guests