retraction bug ?

Discussions about ideaMaker and other printing software.
hackinistrator
Posts: 2
Joined: Sun Jun 28, 2020 6:18 am

retraction bug ?

Postby hackinistrator » Fri Jul 03, 2020 7:43 pm

hello , my first post here :mrgreen:

i'm looking for new slicer post S3D era , as it seems dead , so anyways , i tried IM and i see some weird retraction bugs for no particular reason .
X marks retraction ...
1.jpg

2.jpg

3.jpg

i tried to upload the project file but its too large (approx 5mb)

any idea why is this happening .

User avatar
Vicky@Raise3D
Posts: 6907
Joined: Fri Mar 25, 2016 3:54 am

Re: retraction bug ?

Postby Vicky@Raise3D » Tue Jul 07, 2020 1:55 am

You should be able to remove most of the retraction in your model with enabling Avoid Retraction Inside Model and disabling Enable Retraction at Bottom and Top of models.
https://support.raise3d.com/ideaMaker/5 ... 5-444.html
And also using Rectilinear as your Support Infill Type can avoid a lot unnecessary retractions among supports.
https://support.raise3d.com/ideaMaker/5 ... 5-439.html

hackinistrator
Posts: 2
Joined: Sun Jun 28, 2020 6:18 am

Re: retraction bug ?

Postby hackinistrator » Tue Jul 07, 2020 10:29 pm

hello
i don't see LOGIC behind those retractions . i know how to disable retractions , but i don't want to !
this happens not just on top or bottom layers .

more then 20 retractions per layer might cause extruder clogs .
i also see that i'm not the only one with those issues .

User avatar
Vicky@Raise3D
Posts: 6907
Joined: Fri Mar 25, 2016 3:54 am

Re: retraction bug ?

Postby Vicky@Raise3D » Wed Jul 08, 2020 12:09 am

Retraction is according to Minimal Travel of Retraction and Minimal Amount of Retraction's values. These settings can help increase or decrease retractions.


Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests