Pausing prints

Discussions about ideaMaker and other printing software.
distal2proximal
Posts: 1
Joined: Thu Jun 04, 2020 9:32 pm

Pausing prints

Postby distal2proximal » Thu Jun 04, 2020 9:40 pm

Hi, I'm looking to buy a Raise3d Pro2. I want to embed sensors into parts for a university project I'm working on. Currently I use a prusa i3 that I use with Repetier that enables me to pause the print, place the sensor and resume the print. So, would the Raise3d software allow this? and can I control the printer via repetier? Thanks in advance.

Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests