Feature request : most powerful post-processus

Discussions about ideaMaker and other printing software.
Posts: 2
Joined: Fri May 15, 2020 5:32 am

Feature request : most powerful post-processus

Postby JCDRaise3D » Thu May 21, 2020 5:23 am

I'm not requiring an almost python-like stuff but something more powerful than the simple replace/delete.

Something like replace/delete when variable= VALUE

where variable is something in the GCode written like ;TYPE:SOLID-FILL >>> in this case the variable would be TYPE and its value SOLID-FILL, up until the next GCode line where there is a ;TYPE: text or an EOF

Maybe your Post processus feature is working sequentially on the GCode lines and it would not be a difficult task to improve it

This would allow a task like : I want retraction except in the Solid Fill (suppose the retraction speed is 25mm/s)

{"source":["G1 F1500 E"],"target":[";G1 F1500 E"],"type":"replace","when":"TYPE=SOLID-FILL"}

User avatar
Posts: 6492
Joined: Fri Mar 25, 2016 3:54 am

Re: Feature request : most powerful post-processus

Postby Vicky@Raise3D » Sat May 23, 2020 12:21 am

Thanks for your suggestion. Will forward over to developing team.

Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests