Feature request: Visual adjustment of fixed seam like rotation/move

[FOGD.NO]

When I place a model I have small room where I could place the seam and get a perfect print. So a place where the seam does not matter. Now I have tried wity some X/Y setting by using numbers, but when I placed two models the first got correct placement, while the other got it placed somewhere else. I think this could be done much easier if you get a rotation tool for the start-stop and have choice of from-to Z heigh, each layer or for the whole model.

[Vicky@Raise3D]

Are you looking for different starting point solutions on different models? Or different solutions on different sections of one model?
Would you mind to share some pictures of gcode preview which is having issues with us to show us the issue?

[FOGD.NO]

Are you looking for different starting point solutions on different models? Or different solutions on different sections of one model?
Would you mind to share some pictures of gcode preview which is having issues with us to show us the issue?

https://youtu.be/Nsgcj4Iypvk

If you notice here, it is very cumbersome method to adjust the position of the fixed seam, and the position is the same for several models.

So a visual aid where you could move a X or dot to the place where you want the seam for each object would be perfect.

[Vicky@Raise3D]

Would you like to advise whether you are looking for:
1. Using 3D mode to show the starting points of all the models with 3D Brush.
2. Using Top View Mode to show the starting points XY values.

[FOGD.NO]

Would you like to advise whether you are looking for:
1. Using 3D mode to show the starting points of all the models with 3D Brush.
2. Using Top View Mode to show the starting points XY values.

Both method if possible, but the 3d view and then just click on the position would be great. Then you could just rotate the model and find the best spot.

[Vicky@Raise3D]

Thanks for your confirmation. We will add it into developing list.

[FOGD.NO]

Thanks for your confirmation. We will add it into developing list.

Awesome.. This would be a good improvement for sure

[neslekkim]

Is there any progress on this?, an visual way of placing seam would be very nice.
In the latest Alpha for PrusaSlicer, one can now paint where one want the seam, it's not quite easy to put it accurately yet, but it's atleast much easier to control placement.

[Vicky@Raise3D]

Thanks for the feedbacks.
The request has already been added into developing list. But not the top few priority ones.