Page 1 of 1

Trouble with ramp offset

Posted: Wed Mar 25, 2020 3:37 am
by justinmreina
Hi,
With ideaMaker how can you set the ramp offset for print? I am looking to place 3-4 support layers between my raft and part, have tried:

Attempt:
[*]Support->Vertial Offset Top Layers

But this does not work, see attached. Thoughts?

Re: Trouble with ramp offset

Posted: Thu Mar 26, 2020 2:03 am
by Vicky@Raise3D
The feature is designed for defining the gap between Support and Model in Vertical direction.
The higher the value, the further support will be to the model, the less support.