Trouble with ramp offset

Discussions about ideaMaker and other printing software.
justinmreina
Posts: 1
Joined: Wed Mar 25, 2020 3:28 am

Trouble with ramp offset

Postby justinmreina » Wed Mar 25, 2020 3:37 am

Hi,
With ideaMaker how can you set the ramp offset for print? I am looking to place 3-4 support layers between my raft and part, have tried:

Attempt:
[*]Support->Vertial Offset Top Layers

But this does not work, see attached. Thoughts?
Attachments
config results.zip
offset top layers try (Normal - 1 layer, "I" - 2 layers, "II" - 3 layers, "III" - 0 layers)
(2.61 MiB) Downloaded 20 times

User avatar
Vicky@Raise3D
Posts: 6482
Joined: Fri Mar 25, 2016 3:54 am

Re: Trouble with ramp offset

Postby Vicky@Raise3D » Thu Mar 26, 2020 2:03 am

The feature is designed for defining the gap between Support and Model in Vertical direction.
The higher the value, the further support will be to the model, the less support.


Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests