Cura 4+ with N2 Single

Discussions about ideaMaker and other printing software.
mrmdsims1
Posts: 1
Joined: Sat Nov 09, 2019 1:58 am

Cura 4+ with N2 Single

Postby mrmdsims1 » Sat Nov 09, 2019 2:07 am

I was having a few print quality issues with my N2 Single and decided to try Cura instead of the normal slicing with Ideamaker. The printer is set up properly in Cura and I have verified the extruder count is set to 1. When I try to print a file that was sliced with Cura, I get the following error on the printer - "The printer only has a single extruder and cannot print dual extrusion gcode file". I have uninstalled Cura, loaded older versions, and still run into the same issue.

Any suggestions?

Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests