Hi all when the head moves to the location to hide the seam or moves across the work while not printing it appear the head is not moving far enough away from the bed and drags a mark across the work
Which setting controls this as the manual is a bit confusing on this issue is it:-
1. Z Hop at retraction under the Extruder Tab?
head dragging accross work
Re: head dragging accross work
Yessantro wrote:1. Z Hop at retraction under the Extruder Tab?
Re: head dragging accross work
The problem I have with "Z Hop at Retraction" is it will then hop at the end of every single line it prints during infill, even with "Avoid Retraction Inside Models" is selected. There should be an option "Z Hop Only During Travel moves".
Who is online
Users browsing this forum: No registered users and 2 guests