I am trying to print a file in vase mode and in the cooling section, i have 15 sec minimal layer speed and lowering speed enabled. However, if you look at the attached preview, it is all the same speed and the thin throat is not printing properly obviously. Tried increasing the minimal speed time. Same thing.
Any ideas as to why? Is the lowering speed not taken into consideration in vase mode?
Discussions about ideaMaker and other printing software.
2 posts • Page 1 of 1
Would you like to share .idea, .gcode and .data files with us to have a look?
Who is online
Users browsing this forum: No registered users and 2 guests