Keeping the bed hot

Discussions about ideaMaker and other printing software.
santro
Posts: 7
Joined: Wed Aug 28, 2019 7:08 am

Keeping the bed hot

Postby santro » Wed Aug 28, 2019 8:12 am

Hi all this might end up being a duplicate post not sure where my first post went..
Currently ideamaker is turning the bed temp off after the first few layers, how to I set ideamaker to leave the bed temp on until the print is finished

User avatar
Vicky@Raise3D
Posts: 5510
Joined: Fri Mar 25, 2016 3:54 am

Re: Keeping the bed hot

Postby Vicky@Raise3D » Wed Aug 28, 2019 9:38 pm

If you didn't enable Temperature Control List for Heated Bed, the temperature of bed wouldn't be changed by ideaMaker during the whole printing.
Screenshot_20190828143748.png


Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests