I have a print where I am setting nuts into a hex hole and printing on top of them, so I set in "other" of advanced slice settings for it to pause at the correct layer.
It paused in the right place, but I was unable to resume it. Every time I tried it paused again. Here is a video showing what is happening: https://photos.app.goo.gl/ba2Yhj1e4VPfJY5x5
Am I doing something wrong here? How am I supposed to correctly resume a print paused by M2000?
Discussions about ideaMaker and other printing software.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests