After upgrading my single extrusion N2 to RaiseTouch 1.2.0, I'm getting an error message in RaiseTouch, telling me that there are dual extrusion commands in my print file. It doesn't ask me if I would like to print anyways, it just denies to print!
I'm printing with the same settings since months with older RaiseTouch software. Maybe there are dual extrusion commands within my GCODE, but the whole thing is a single extrusion print!
To be able to print again, I've set 2 nozzles in the printers preferences for now. But come on Raise3D, you can't really do that!
Also, there is no hint about it in the release notes!
Discussions about ideaMaker and other printing software.
2 posts • Page 1 of 1
Would you like to share gcode file with us to check what is causing the issue?
Who is online
Users browsing this forum: No registered users and 2 guests