Marlin Software

Discussions about ideaMaker and other printing software.
Posts: 1
Joined: Wed Dec 05, 2018 3:03 pm

Marlin Software

Postby aceman » Wed Dec 05, 2018 7:42 pm


I am using the Marlin | Arduino 1.8.7. I’ve used other type software before for programming PIC basic compliers, “BTW I wasn’t much good at it.”

All I want to do is, and hopefully it's not to difficult, how do get the compiled configuration.h file so its .firm file so I can load into the printer?

Any help will be gratefully welcome.


Return to “Software”

Who is online

Users browsing this forum: No registered users and 1 guest