Page 3 of 3

Re: Major Update & Improvements for Pro2 and N Series

Posted: Fri Oct 18, 2019 7:50 pm
by Vicky@Raise3D
You can try the feature called Cool Down Inactive Extruder so that the temperature of the used nozzle will be reduced to the lower target temperature you set when it is not printing.
WipeWall and Wipe Tower can also help wipe the leaking filament on nozzle tips.

Re: Major Update & Improvements for Pro2 and N Series

Posted: Mon Oct 21, 2019 3:49 pm
by AirtomicEng
Vicky@Raise3D wrote:You can try the feature called Cool Down Inactive Extruder so that the temperature of the used nozzle will be reduced to the lower target temperature you set when it is not printing.
WipeWall and Wipe Tower can also help wipe the leaking filament on nozzle tips.


I'm not talking about oozing. I'm talking about the printhead actually pushing filament through the nozzle before it starts moving and it always does this right after switching nozzles.

Here is the sequence:
1. Finish printing first layer with left nozzle
2. Switch nozzle
3. move printhead to ooze tower position
3. extrude blob of material onto plate/previous layer.
4. try to continue printing.

Re: Major Update & Improvements for Pro2 and N Series

Posted: Tue Oct 22, 2019 9:38 pm
by Vicky@Raise3D
Would you like to show how big the blob was? What temperature and template you are using to print for both nozzles now?

Re: Major Update & Improvements for Pro2 and N Series

Posted: Fri Feb 07, 2020 1:57 pm
by Fleurnoir
Vicky@Raise3D wrote:
claytony565 wrote:
Would you like to share the .idea, .gcode and .data files with us to test?


It turns out it was a broken coupler, it just so happened to be at the same time I had done the updates.


Thanks for your update!