Major Update & Improvements for Pro2 and N Series

Discussions about ideaMaker and other printing software.
User avatar
Vicky@Raise3D
Posts: 5837
Joined: Fri Mar 25, 2016 3:54 am

Re: Major Update & Improvements for Pro2 and N Series

Postby Vicky@Raise3D » Fri Oct 18, 2019 7:50 pm

You can try the feature called Cool Down Inactive Extruder so that the temperature of the used nozzle will be reduced to the lower target temperature you set when it is not printing.
WipeWall and Wipe Tower can also help wipe the leaking filament on nozzle tips.

AirtomicEng
Posts: 12
Joined: Fri Oct 04, 2019 8:16 pm

Re: Major Update & Improvements for Pro2 and N Series

Postby AirtomicEng » Mon Oct 21, 2019 3:49 pm

Vicky@Raise3D wrote:You can try the feature called Cool Down Inactive Extruder so that the temperature of the used nozzle will be reduced to the lower target temperature you set when it is not printing.
WipeWall and Wipe Tower can also help wipe the leaking filament on nozzle tips.


I'm not talking about oozing. I'm talking about the printhead actually pushing filament through the nozzle before it starts moving and it always does this right after switching nozzles.

Here is the sequence:
1. Finish printing first layer with left nozzle
2. Switch nozzle
3. move printhead to ooze tower position
3. extrude blob of material onto plate/previous layer.
4. try to continue printing.

User avatar
Vicky@Raise3D
Posts: 5837
Joined: Fri Mar 25, 2016 3:54 am

Re: Major Update & Improvements for Pro2 and N Series

Postby Vicky@Raise3D » Tue Oct 22, 2019 9:38 pm

Would you like to show how big the blob was? What temperature and template you are using to print for both nozzles now?


Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests