I would like know if it is possible using Ideamaker, cut the model in two parts and make a gcode that prints the first part with default parameters but second part must be print in spiralize mode.
Problem is that I have a model (like a vase) with an hole on the base and if I print all in spiralize, slicer "close" the hole.
I have searched in the "group and layer settings" but I have not found anything on the spiralize.
Somebody can help me please?
Discussions about ideaMaker and other printing software.
2 posts • Page 1 of 1
As Spiral Vase Mode is continuous moving XY and Z directions together for the whole height of the model, not move Z once finish everything at one layer. So you cannot use Vase Mode together with normal layer print at the one print.
Who is online
Users browsing this forum: No registered users and 1 guest