N2 bed moves to -100Z on cancel

Discussions about ideaMaker and other printing software.
Posts: 72
Joined: Thu Sep 21, 2017 2:14 pm

N2 bed moves to -100Z on cancel

Postby pearson222 » Fri Jul 27, 2018 9:16 pm

I have (2) N2 Plus Duals. They are both running 1.1.6-rev1 firmware. Sending both of them the same print file and cancel the prints - one printer will move Z-10 and the other will move z-100. How can I get both of them to only move Z-10 on cancel?

Alex M.
Posts: 194
Joined: Tue Apr 10, 2018 4:59 pm

Re: N2 bed moves to -100Z on cancel

Postby Alex M. » Fri Jul 27, 2018 9:53 pm

Look at "Added an option to set the Z position of print bed dropping to after print stopped under Setting -> More Settings -> Advanced Settings." in this thread: viewtopic.php?f=3&t=8439

Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests