retraction on top and bottom layers

[r.lisci]

Hello,
Can you explain to me why it does not retract at the marked point? I set "avoid retraction inside model" but also "enable retraction at bottom and top of models" each of 2 layers. In the image there is the second layer.

It also happens on other top and bottom layers of the model.

thanks a lot

[Vicky@Raise3D]

Can you save your model as .idea in ideaMaker and share with us to run some test?

[r.lisci]

of course, here it is.
thanks

[Vicky@Raise3D]

Do you mind share us the .gcode and .data files sliced with this .idea file?
We use our setting but cant recreate the same issue. We want to compare with your settings and result.

[r.lisci]

thank you

[r.lisci]

i find the problem on all models. In the image you can see the top surface solid fill layer, there is retraction when change wall of hole, but not when move to another position.

P.S.
I don't know why on 2 of 4 hole retracts between inner and outer sheel and in the other 2 no (minimal travel of retraction set to 0.80mm)

[Vicky@Raise3D]

We have tried to slice with your .diea file but cant recreate the same issue.
Can you share your .gcode and .date files so that we can compare our settings with yours?

[r.lisci]

how can create a .data file?

[Vicky@Raise3D]

After slicing completes, ideaMaker will create .data file together with .gcode file. You should be able to find both files under the same folder.

[r.lisci]

i'm able to see only gcode file.
any suggestions?

[GonzoG]

In printer settings, Advanced tab you can select to create *.data files

[r.lisci]

In printer settings, Advanced tab you can select to create *.data files

thanks