Font is too large, descriptions cut off

[Meetloaf13]

I am having an issue. I have anew laptop, that is natively 4K, but I run 3 monitors at 1080p.

When I launch ideaMaker 4.0.1, the scaling is off and many of the descriptions are cut off, making it difficult to view and alter settings:

I have tried to alter the font family/size, but when I change these settings and hit OK, the changes do not take effect and revert back to the default settings.

None of my other softwares are suffering from this.

Any help would be much appreciated. I've found that IdeaMaker is giving me better quality prints than Cura, and I'd like to continue using it.

Thank you

[Vicky@Raise3D]

If you are running ideaMaker with Windows 10, please adjust DPI settings according the screeshot below and restart ideaMaker.

[Meetloaf13]

Bummer, no dice there.

I wonder if it needs a system restart.

[Vicky@Raise3D]

Make sure the customize font settings in ideaMaker has been disabled and close ideaMaker then reboot the computer.
https://support.raise3d.com/ideaMaker/4 ... 5-814.html