Problem with firmware update for Hyper Speed

sonix · Postby **sonix** » Wed Sep 20, 2023 10:40 am

Hello,
today I wanted to update the firmware to use de Hyper Speed kit and since half an hour I see this image.
What can I do?
Thanks
Sven

Matthias1982 · Postby **Matthias1982** » Thu Sep 21, 2023 8:51 am

restart the printer as said on the display... and leave the USB-Drive pluged like it is on your picture ;-)

sonix · Postby **sonix** » Thu Sep 21, 2023 1:48 pm

Right, sorry :roll:

Manuel@Raise3D · Postby **Manuel@Raise3D** » Fri Sep 22, 2023 11:10 pm

Was this issue resolved by following the on-screen promt after all or were there still any issues with the update?

sonix · Postby **sonix** » Wed Sep 27, 2023 6:45 am

Hi,
The "problem" was solved by the instruction. There were no further problems

thx

Manuel@Raise3D · Postby **Manuel@Raise3D** » Thu Sep 28, 2023 12:34 am

it's good to hear that the issue was resolved after all.

Official Raise3D Community