Right extruder does not match the image in IdeaMaker

Reo
Posts: 5
Joined: Mon May 09, 2022 6:49 pm

Right extruder does not match the image in IdeaMaker

Postby Reo » Mon Aug 01, 2022 3:18 pm

Hello everyone

I have the problem that ideaMaker graphically displays the building board and the arrangement correctly. But the printer then prints the whole thing much further to the left. So it separates a bit from the object. The whole thing is with the right extruder.

Pictures attached as an example.

The first how it looks on the printer. The circles at the very end are clipped and not printed cleanly.
In the second shows the arrangement in Ideamaker.

Is anyone having the same problem? And if so, have you already found a solution? Or is this a general bug?


Best regards Reo
Attachments
Muster Ideamaker Pro3.jpg
Muster Ideamaker.jpg

User avatar
Ryan@Raise3D
Posts: 604
Joined: Thu Oct 28, 2021 10:43 pm

Re: Right extruder does not match the image in IdeaMaker

Postby Ryan@Raise3D » Sat Aug 13, 2022 1:06 am

The screen you are seeing in ideamaker is the actual build volume of the printer and on the printer itself there is a bit of space to the right and back of the machine that it cannot reach. This does not change the advertised build volume.

D_E
Posts: 9
Joined: Thu Jul 21, 2022 12:41 pm

Re: Right extruder does not match the image in IdeaMaker

Postby D_E » Tue Aug 30, 2022 1:37 pm

Ryan@Raise3D. It still doesn't match. In fact, when printing within the printable area (away from the print zone) the printed part can sometimes be cut in half due to these dimensions not being correct within the profile.

User avatar
Ryan@Raise3D
Posts: 604
Joined: Thu Oct 28, 2021 10:43 pm

Re: Right extruder does not match the image in IdeaMaker

Postby Ryan@Raise3D » Thu Sep 01, 2022 12:49 am

Can you send the Gcode file for the prints having this issue so I can see what may be causing your issue?

Reo
Posts: 5
Joined: Mon May 09, 2022 6:49 pm

Re: Right extruder does not match the image in IdeaMaker

Postby Reo » Fri Sep 02, 2022 6:52 pm

Hi

Attached is the file.
The problem is that it should work in the preview. On the printer, however, it is shifted much further to the left, so the two parts on the left are not printed. So not quite.

Best regards
Reo
Attachments
Cryptex Einstellringe (10 Teile).zip
(8.13 MiB) Downloaded 30 times

User avatar
Ryan@Raise3D
Posts: 604
Joined: Thu Oct 28, 2021 10:43 pm

Re: Right extruder does not match the image in IdeaMaker

Postby Ryan@Raise3D » Sat Sep 03, 2022 12:53 am

Thank you for the update. The only thing that could make sense here is if the offset calibration for the right hot end is off by a significant value and to double check this can I have you click the gear icon in the top corner of the touch screen → click more settings → click hardware → click extruders and send a picture of this page as this is where the offsets are stored.


Return to “Pro3 Series”

Who is online

Users browsing this forum: No registered users and 2 guests