Left & Right Filament Flowrate Override isn't

[twiget]

I'm trying to calibrate the filament flow through each extruder, so I printed the standard single wall hollow cube on both extruders (in duplication mode) and measured the wall thicknesses. Both cubes measured 0.44mm all the way around, so I crunched some numbers and I updated the Left and Right Filament Flowrate override settings in the Advanced tab of Ideamaker and printed the cubes again with the new settings. Again I got 0.44mm wall thickness. Layer height is 0.2mm and shells is 1.0 and infill is at 0%.

All the various flow rates are set at 100% and according to the tool tip, this override should control all the those flowrates in Ideamaker. How do I adjust the flow rates? I need to print some print in place objects and this over extrusion is gluing the moving parts together.

[Vicky@Raise3D]

Can you share the version of ideaMaker you are using and screenshots of before and after the values modified and not updated with us?

Thank you!