How do you do z offset with a copperhead?

Jtsessions
Posts: 4
Joined: Sun Aug 01, 2021 9:32 pm

How do you do z offset with a copperhead?

Postby Jtsessions » Sun Jul 31, 2022 7:56 am

Just got two copperheads. I searched forums and found that people needed 20c on top of the 200c the guided z offset uses to print or they had adhesion issues. Raise said the parameters were for stock to reduce variables.

Fair enough.

I know I can adjust the offset manually, but how do you all dial yours in? Do you use any special prints? The auto method is so handy that I'm not sure what a good process to do it manually looks like.

Return to “E2”

Who is online

Users browsing this forum: No registered users and 1 guest