Page 1 of 1

Z - axis shaft squeaking noise

Posted: Wed Oct 13, 2021 6:26 pm
by aimeri42
Dear all,

- The Z-shaft (one of them in the left side) is making a squeaking noise only while going down.
- The printer is new and has only 8 total hours of printing. The lubricant seems to be removed by the motion of the print head. I am not sure whether the shaft is not aligned or the bearing is too tight.
- Attached you will find the video.
Looking forward to your suggestions.
P.S I have another Raise 3D E2 printer with 400+ hours with drier shafts and works just fine.

Sincerely,

Re: Z - axis shaft squeaking noise

Posted: Thu Oct 14, 2021 2:33 am
by Steven@Raise3D
aimeri42 wrote:Dear all,

- The Z-shaft (one of them in the left side) is making a squeaking noise only while going down.
- The printer is new and has only 8 total hours of printing. The lubricant seems to be removed by the motion of the print head. I am not sure whether the shaft is not aligned or the bearing is too tight.
- Attached you will find the video.
Looking forward to your suggestions.
P.S I have another Raise 3D E2 printer with 400+ hours with drier shafts and works just fine.

Sincerely,


I would suggest creating a support ticket so that one of our technical support engineers can assist you in resolving this issue.