Page 1 of 1

When can we expect Klipper like Input Shaper on our E2 firmwares? :)

Posted: Sat Apr 10, 2021 12:03 am
by X3msnake
Based on this video

We just got a E2 to replace both our Ultimaker 3 Extended and BQ witbox and so far we are in love with the machine reliability

But all that is good can always be better. The surface finish is shiny and well defined but it has ringging running with stock template parameters. something like input shaper would allow not only to speed up the machine but also reduce or remove completely these small surface artifacts