Page 1 of 1

E2 Gantry rail length

Posted: Mon Apr 05, 2021 12:30 pm
by Stalebread2008
Hi does anyone know the length of the gantry rail on the E2?

Re: E2 Gantry rail length

Posted: Wed Apr 07, 2021 12:28 am
by Steven@Raise3D
Stalebread2008 wrote:Hi does anyone know the length of the gantry rail on the E2?


The length of the linear rail on the X-axis is 425mm.

Re: E2 Gantry rail length

Posted: Thu Apr 08, 2021 7:08 pm
by Stalebread2008
Steven@Raise3D wrote:
Stalebread2008 wrote:Hi does anyone know the length of the gantry rail on the E2?


The length of the linear rail on the X-axis is 425mm.



Do you know the rail hole spacing, and distance from the edge to first hole, block length and hole spacing? Sorry if its too much. Thanks.

Re: E2 Gantry rail length

Posted: Thu Apr 08, 2021 9:16 pm
by Stalebread2008
Nevermind I got them, but a confirmation would be nice

Re: E2 Gantry rail length

Posted: Tue Apr 13, 2021 10:21 pm
by Steven@Raise3D
Stalebread2008 wrote:Nevermind I got them, but a confirmation would be nice


From the edge of the rail to the first fastener is 10mm

The distance between each fastener is 25mm from center point to center point.

Re: E2 Gantry rail length

Posted: Sat Apr 17, 2021 7:14 pm
by Stalebread2008
Steven@Raise3D wrote:
Stalebread2008 wrote:Nevermind I got them, but a confirmation would be nice


From the edge of the rail to the first fastener is 10mm

The distance between each fastener is 25mm from center point to center point.


10mm to the edge of the first hole or the center?

Re: E2 Gantry rail length

Posted: Tue Apr 20, 2021 12:08 am
by Steven@Raise3D
Stalebread2008 wrote:
Steven@Raise3D wrote:
Stalebread2008 wrote:Nevermind I got them, but a confirmation would be nice


From the edge of the rail to the first fastener is 10mm

The distance between each fastener is 25mm from center point to center point.


10mm to the edge of the first hole or the center?


10mm to the edge of the fastner.

Re: E2 Gantry rail length

Posted: Sat Apr 24, 2021 9:09 pm
by Stalebread2008
Steven@Raise3D wrote:
Stalebread2008 wrote:
Steven@Raise3D wrote:
From the edge of the rail to the first fastener is 10mm

The distance between each fastener is 25mm from center point to center point.


10mm to the edge of the first hole or the center?


10mm to the edge of the fastner.


So would that be 12.5 from the center?

Re: E2 Gantry rail length

Posted: Wed Apr 28, 2021 12:12 am
by Steven@Raise3D
Stalebread2008 wrote:
Steven@Raise3D wrote:
Stalebread2008 wrote:
10mm to the edge of the first hole or the center?


10mm to the edge of the fastner.


So would that be 12.5 from the center?


Yes, from the edge to the center of the first fastener would be 12.5mm.