x and u will collide error

[Engineer87]

Has anyone else received an error with their E2 that tells them that "X and U axes will collide" forces a restart and won't print the file?
I'm printing a 40mm single-wall extruder calibration cube from the right extruder. I'm only using the right extruder for the print.
It does this after performing the leveling routine, what seems like multiple times.
log file attached. Raise 3D, your input would be great here.

[Proschi3d]

Did you choose the right printer profile in your slicer ?

[Zoet]

I think that something similar happened to me a few days ago...

Where is your cube located ? Do you use a raft or a brim ?

[Engineer87]

It was to the right of center but within the build space overlapping both extruders. It was a brim only

[Engineer87]

Did you choose the right printer profile in your slicer ?

Yeah, it was an e2 for the printer. How can the profile cause problems? Wondering if this is related to the z offset.

[Proschi3d]

Once I accidentally installed a filament profile of the Pro2, the result was the same error code.

[Steven@Raise3D]

Has anyone else received an error with their E2 that tells them that "X and U axes will collide" forces a restart and won't print the file?
I'm printing a 40mm single-wall extruder calibration cube from the right extruder. I'm only using the right extruder for the print.
It does this after performing the leveling routine, what seems like multiple times.
log file attached. Raise 3D, your input would be great here.

Can you please attach the Gcode file that you were attempting to print when the error appeared?

[Bikeracer]

It does this after performing the leveling routine, what seems like multiple times. .

You can switch off the bed leveling before each print in the control panel.