Page 1 of 1

@Vicky

Posted: Thu Dec 17, 2020 11:46 am
by Proschi3d
can i have a full pinout from the Motionboard,please

As the board says based on the Duet2Wifi then I suppose they would have to comply with the open source license and provide the schematic (and layout files)?

for a better understanding of the problem you can read here what it is about

https://forum.duet3d.com/topic/20405/du ... e-3d-e2/27

Re: @Vicky

Posted: Thu Dec 17, 2020 12:14 pm
by Allram
You might be able to find something here: https://github.com/Raise3D/Reprap-Raise3D-E2-Series

Re: @Vicky

Posted: Thu Dec 17, 2020 12:20 pm
by Proschi3d
thanks, but that doesn't give me the pin assignment

Re: @Vicky

Posted: Thu Dec 17, 2020 12:52 pm
by Proschi3d
Allram wrote:You might be able to find something here: https://github.com/Raise3D/Reprap-Raise3D-E2-Series


Has anyone done it yet?

Re: @Vicky

Posted: Fri Dec 18, 2020 2:24 am
by Steven@Raise3D
All of the information that we have for the motion controller board has been published on our Github. https://github.com/Raise3D/Reprap-Raise3D-E2-Series

Re: @Vicky

Posted: Thu May 13, 2021 7:52 am
by gtsh_user_1
Now... this is extremely useful and I have been looking for it for a while.

Could this information be pinned to the top of the forum to save others the time to search? Are there other repositories that should also be mentioned?

Regards,

GTSH