I just received my E2 and after some test prints I recognise that Z-Offset is to high - something about 0.2mm. Ok, I found the instruction how to calibrate Z-Offset here: https://support.raise3d.com/E2/how-to-a ... -1228.html
But I can complete step 5 because of Board Error:
I repeated this step several times but with the same result.
4 posts • Page 1 of 1
I installed latest firmware (0.2.506) for E2 printers and it seams to be ok now. But it was necessary to be done manually, because RaiseTouch "Update automatically" doesn't work properly and always displays I had latest version.
Who is online
Users browsing this forum: Bikeracer and 1 guest