I'm hoping someone can offer some advice for using the E2 in duplication mode.
If I don't use a raft, one side doesn't stick to the bed. If I do use a raft, it is impossible to remove the parts from the raft.
2 posts • Page 1 of 1
Try use brims. (platform additions). I use an electronic cleaning spray or similar to clean print bed before print. Usually it help. Make your first layer extrusion persentage(layer in ideamaker) like 150% or smt. So that first layer stick better. I have never used rafts. Few times problems whit part dont stick in bed.
Who is online
Users browsing this forum: No registered users and 1 guest