In the wee small hours of last night my Pro2 ran out of filament. I got up to pay it some attention (which activity led to it being named THE_BABY ) and discovered that the print head had jumped out of register. Actually, quite a jump!
Any ideas what would have caused the print head to leap that far off 'Y' registration?
I have attached my ideaMaker print template.
Thoughts about Raise3D, 3D printing and making in general.
3 posts • Page 1 of 1
It is very likely that the hot end caught the part and caused this layer shift and when it broke free it continued the print in the wrong place. Can you let me know how long the print was left in the paused state due to the runout?
Who is online
Users browsing this forum: Google [Bot] and 2 guests