Page 1 of 1

Possible to manually PLCs the wipe tower?

Posted: Wed Jun 09, 2021 1:15 pm
by MarnelKelis
I’m using a pro 2. I have a model that takes up pretty much the whole bed but has huge spaces within it. If I could place the wipe tower in one of these spaces I’d be fine but there isn’t room outside the part for it. Slicing with ideamaker. Thanks in advance!

Re: Possible to manually PLCs the wipe tower?

Posted: Thu Jun 10, 2021 2:21 am
by Vicky@Raise3D
If you are looking for fixing the Tower at the fix coordinate position, you can enable Placed at the Fixed Position of the Plateform.
https://support.raise3d.com/ideaMaker/5 ... 5-444.html