Using a micro switch as a filament run out sensor.

Thoughts about Raise3D, 3D printing and making in general.
rattlemycage
Posts: 14
Joined: Tue Jan 21, 2020 2:31 pm

Using a micro switch as a filament run out sensor.

Postby rattlemycage » Sat Sep 12, 2020 4:46 am

I have seen run out sensors that have a micro switch mechanism. They are N/O or N/C connections.

Has anyone tried this approach?

From what I can grasp from the original Raise run out sensor information , the two wires from the micro switch should be made to Y+ and Z+.
But which pins?

Thanks
Screenshot (1525).png
Screenshot (1525).png (93.06 KiB) Viewed 49 times

Return to “General”

Who is online

Users browsing this forum: No registered users and 2 guests