Sketch does not extrude

Thoughts about Raise3D, 3D printing and making in general.
User avatar
Vagulus
Posts: 182
Joined: Mon Mar 25, 2019 5:27 am

Sketch does not extrude

Postby Vagulus » Mon May 11, 2020 2:52 am

Sketch 25 in the attached ZIP refuses to extrude. It should form a flange plate 4mm thick up from the sketch (without the two bolt holes).
Sketch is fully constrained and as far as I can tell all the corners connect properly. All I can get from the Extruder Command is
Inventor Error.png
Inventor Error.png (9.6 KiB) Viewed 184 times


Someone please have mercy on what is left of my hair and tell me why.

Thanks
Attachments
CT-02-005.zip
(214.17 KiB) Downloaded 12 times
--------------------------------------------
God so loved the World that
He did not send a Committee

User avatar
Vagulus
Posts: 182
Joined: Mon Mar 25, 2019 5:27 am

Re: Sketch does not extrude

Postby Vagulus » Mon May 11, 2020 9:34 pm

Sorry folks. Wrong Forum! :cry:
'Nuther day wasted. :roll:
My Bad! :x
--------------------------------------------
God so loved the World that
He did not send a Committee


Return to “General”

Who is online

Users browsing this forum: No registered users and 2 guests