Thoughts about Raise3D, 3D printing and making in general.
Posts: 5
Joined: Fri May 03, 2019 2:05 pm


Postby bdrmachine » Mon Apr 27, 2020 10:27 pm

I would like to use Slic3R on my Pro2 printer. Has anyone out there done this? What settings do I use to post the G-code, ReprapLinuxCnC, etc ????

Posts: 4
Joined: Sat Jan 04, 2020 9:55 pm

Re: Slic3r

Postby hommelm » Fri May 01, 2020 8:09 pm

I tried the same today.
You must choose "Smoothie" under Printer Settings / Firmware / G-Code flavor

Return to “General”

Who is online

Users browsing this forum: Google [Bot] and 2 guests