After NINE attempts I finally had my Pro2 print infill at 25%
and support at 10%
Why did it take so many attempts? Because adjustments to the percentage figures of two or three percent gave me bigger jumps in the sizes actually printed. I couldn't get what I wanted. I still don't have precisely what I want but what I have is acceptable.
I have come to the conclusion that ideaMaker only accepts changes in the percentages in 5% increments. I can't for the life of me figure out why that would be but it seems to work. Has anyone else had the same experience?
Thoughts about Raise3D, 3D printing and making in general.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests