Support anf Infill Percentages

Thoughts about Raise3D, 3D printing and making in general.
User avatar
Vagulus
Posts: 84
Joined: Mon Mar 25, 2019 5:27 am

Support anf Infill Percentages

Postby Vagulus » Mon Oct 07, 2019 1:25 am

After NINE attempts I finally had my Pro2 print infill at 25%
191007-InfillAt25.JPG

and support at 10%
191007-SupportAt10.JPG


Why did it take so many attempts? Because adjustments to the percentage figures of two or three percent gave me bigger jumps in the sizes actually printed. I couldn't get what I wanted. I still don't have precisely what I want but what I have is acceptable.

I have come to the conclusion that ideaMaker only accepts changes in the percentages in 5% increments. I can't for the life of me figure out why that would be but it seems to work. Has anyone else had the same experience?
--------------------------------------------
God so loved the World that
He did not send a Committee

Return to “General”

Who is online

Users browsing this forum: No registered users and 2 guests