Just wondering if anyone here has successfully printed with Color Fabb BronzeFill. We just got some, but after trying 3 diff layer heights(0.10, 0.20, 0.30) and 3 diff print temps(205c, 205c, 220c), all we can get is filament jams.
We can load the filament and extrudes fine prior to print, but as soon as its gone an inch or two on the print bed, the filament stops and feed gears start clicking.
We can then "unload" the filament until the tip gets to the filament feed orifice above the gears. Apparently the lower tip diameter is to large to fully unload through the upper section.
Thoughts about Raise3D, 3D printing and making in general.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests