On monday i've updated the firmware of my Raise 3D Pro 2 plus raise touch to 1.2.1
After that for the first short prints: no problem
But now i've got a 78hours long print and the print failed after 10hours saying "error card sensor 10, please restart the printer"
I've restarted the printer and cancelled the print.
After that i've done 5 short prints without any problem and yesterday evening i've launched again the 78hours print.
This morning: suprise, the print was stopped and the same message appeared.
Is it due to the firmware update ?
An other thing, i've read that with the update we were able to get mp4 video files instead of mjpg (unreadable without conversation) but i didn't found this option in the menu, is it available ?
Thanks in advance
Thoughts about Raise3D, 3D printing and making in general.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests